A simple code

Discussion in 'Electronics Resources' started by ABShah, May 22, 2011.

Thread Status:
Not open for further replies.
  1. ABShah

    Thread Starter New Member

    May 17, 2011
    Hi I am trying to interface a stepper motor with an 8051 MicroController using a UCN5804 IC. All I have to do is to just make the motor run. I do not ave to connect the the load to the motor. This is a very basic project. However, I have not been able to find a code and schematic for this project. Can any one help me out. I got a little bit help from the datasheet of UCN5804 but it does not show how to connect the 5804 I.C. with the MC.
    Also what program do I need to load in to the MC to make the motor rotate continuously.
  2. bertus


    Apr 5, 2008
Thread Status:
Not open for further replies.