30amp Aga Control unit. repair...?

Discussion in 'General Electronics Chat' started by rekab69, Jun 11, 2011.

  1. rekab69

    Thread Starter New Member

    Jun 11, 2011
    Hi All,

    Not sure if I'm even in the right place to ask but have been banging my head against the wall for sooo long...

    I have a Mk1 30 amp electric Aga which has it's main core temp governed by switching the main neutral feed to the elements by means of a triac, this triac had a poor spade connection which caused it to melt the triac, in turn putting excess current back down the triac gate feed and blowing the contol unit. Diamond H Control is the make of the unit. I found and replaced two burnt resistors but still no luck.

    Does anyone know of a company or clever chap who could repair or replace this unit?


  2. Snikwah

    New Member

    Oct 9, 2011

    Did you ever get the help you needed? I ask because I am in the same position!

    There is an outfit that does replacement controllers for the Mk 1, and I am pursuing that route . . .