What is the best chemical that I could use to clean the PCB's after a thorough reflow.
I am using thinner and Acetone, since this is what I can easily get here.
But it does not do a good job. I am using a paint gun to spray it and clean the board.
Thinner leaves an oily residue and sometimes it gives me trouble.
Acetone is clean but it does not dissolve flux too easily.
What are the chemicals used in PCB industries to clean the PCB after soldering?
I am using thinner and Acetone, since this is what I can easily get here.
But it does not do a good job. I am using a paint gun to spray it and clean the board.
Thinner leaves an oily residue and sometimes it gives me trouble.
Acetone is clean but it does not dissolve flux too easily.
What are the chemicals used in PCB industries to clean the PCB after soldering?