Hello,
I have this system;
1.An encoder as pulse and direction source
2.a driver
3.a stepper motor that follows the encoder I move manually.
What I need is to digitally set a ccw limit and a cw limit with the push of respective buttons on a panel,after positioning the encoder on each limit.
In short, I need to set a range of rotation.
No Pc at all nor physical switches (hard limits) .Then delete them to set another two limits.Also this two positions must be memorized even at power off.
please note this must be acomplished without Pc , plc or any software involved (of course, when operating)
Any thoughts to achieve this with an additional board to my system?
I have this system;
1.An encoder as pulse and direction source
2.a driver
3.a stepper motor that follows the encoder I move manually.
What I need is to digitally set a ccw limit and a cw limit with the push of respective buttons on a panel,after positioning the encoder on each limit.
In short, I need to set a range of rotation.
No Pc at all nor physical switches (hard limits) .Then delete them to set another two limits.Also this two positions must be memorized even at power off.
please note this must be acomplished without Pc , plc or any software involved (of course, when operating)
Any thoughts to achieve this with an additional board to my system?
Last edited: