Hello everyone there?
I am wonderring how to place the sense properly in OrCAD?
Because when I route a sense from a power line with shunt, a ARTWORK engineer feels harder to place the shunt.
But if i just route a sense without the shunt, I should control the every each sense line guide for a artwork engineer.
Is there any good options in OrCAD for it?
Thanks
I am wonderring how to place the sense properly in OrCAD?
Because when I route a sense from a power line with shunt, a ARTWORK engineer feels harder to place the shunt.
But if i just route a sense without the shunt, I should control the every each sense line guide for a artwork engineer.
Is there any good options in OrCAD for it?
Thanks