take a look at the links of this page:
You don't have to know everything, if you know where to find it.
When you do ask questions, you may look stupid.
When you do NOT ask questions, you will STAY stupid.
It would be nice to have the Timezone ( GMT +/- x ) in the location field in the profile.
(User CP -> Edit Your Details)
IPC have made a set of recommendations or a standard for industry. This is named IPC-2221 http://tinymicros.com/wiki/File:IPC-2221.pdf. But note this is for the industry. If you are planing on doing a home made PCB. Well then it is more a question about manufacturing Here is a good guide for this kind of PCB http://www.electricstuff.co.uk/pcbs.html. I may also support you with some more hints if you need them
|Related Site Pages|
|Worksheet||Electromechanical relay logic|
|Textbook||Switch contact design : Switches|
|Worksheet||Printed circuit board layout and manufacture|
|Textbook||ElectroStatic Discharge : Practical Analog Semiconductor Circuits|
|Video Lecture||Troubleshooting Series Circuits - Circuit Troubleshooting|
|Video Lecture||Electronic Components - Basic Components and Technical Notation|
|Video Lecture||Wire and Cable - Basic Components and Technical Notation|
|Textbook||Fuses : Physics Of Conductors And Insulators|
|Textbook||Building simple resistor circuits : Series And Parallel Circuits|
|Thread||Thread Starter||Forum||Replies||Last Post|
|First PCB board which DIY method? Using Kinkos, Staples etc. ?||spinnaker||General Electronics Chat||45||04-27-2010 03:12 PM|
|OrCAD Capture to Allegro PCB conversion||Darren Holdstock||General Electronics Chat||0||01-28-2010 08:44 AM|
|Project works fine on a breadboard, but not on a PCB?||kris_maher||General Electronics Chat||15||10-23-2009 04:51 PM|