|
|
|||||||
| Embedded Systems and Microcontrollers Discussion forum for projects and working with embedded systems and microcontrollers (FPGAs, PICs, AVRs). Get help with hardware issues and embedded programming. |
|
|
|
Thread Tools | Display Modes |
|
#1
10-30-2009, 04:53 PM
|
|||
|
|||
I2C
I hope this is the proper place to post this questions. I tried NXP I2C fourm but it appears to be shut down (not working anymore) I have an I2C spec question. For fast-mode 400kHz the spec is confusing about the rise and fall time spec is there a minimum spec or not. Upper limit is clear at 300 ns but I have heard lower limit is 20 ns but not sure this is true. Also the I/O capacitance loading for measing rise and fall time is not clear either. Spec says 0.1 Cb were Cb is the total bus capacitance. a fully loaded bus is 400 pf so does that mean 40 pf is the loading for testing rise and fall time. Thanks for any help anyone can provide and if this is not the place for this question if you know where I can post this I would be happy to move it there.
|
|
#2
10-30-2009, 05:30 PM
|
||||
|
||||
Here is a link to an information source - http://www.i2c-bus.org/
__________________
First comes the hardware, then the software.
|
|
|
| Bookmarks |
| Tags |
| i2c |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I2C Interface / Current Sensor | EVandEM | The Projects Forum | 6 | 10-08-2009 03:55 AM |
| Cheapest Microcontroller with I2C & UART for industrial use? | timevision | Embedded Systems and Microcontrollers | 11 | 09-03-2009 10:59 AM |
| I2C mode? | sanwa | General Electronics Chat | 2 | 02-27-2009 11:34 AM |
| I2C multimaster. Switching PIC between being a Master and a Slave. | kender | Embedded Systems and Microcontrollers | 0 | 09-04-2008 08:19 PM |
| Relationship Between I2C and North and South Bridgs | Eplanet | General Electronics Chat | 1 | 10-30-2007 07:00 AM |
Linear Mode
