i have designed a fly back converter according to a book- switching power supply design by abraham i. pressman, keith billings, taylor morey.
i have to simulate this designed fly back converter in matlab simulink.
now my first doubt is;
a) i am using a multi winding transformer in place of fly back transformer. is that correct?
b) the design parameters are not utilized in this multiwinding transformer. for eg: there is no way i can feed the turns ratio of the transformer. i hope my doubt is clear to all of u.
c) in the block parameters of multiwinding transformer as soon as i enter the value of r1,r2 o l1,l2 or lm, rm the output becomes inversely reducing. whereas if the all these values are 0 i get the correct output.
please tell wat mistake i am doing.......
the design parameters are:
Po=2Kw
Vo=380V
Vi=80-100V
Fs=40Khz
turn's ratio=1.3123
Ton=13.82 usec
T=20 usec
Lp=12.20uH
Co=115.26uF
Ro=72.2Ω
i have to simulate this designed fly back converter in matlab simulink.
now my first doubt is;
a) i am using a multi winding transformer in place of fly back transformer. is that correct?
b) the design parameters are not utilized in this multiwinding transformer. for eg: there is no way i can feed the turns ratio of the transformer. i hope my doubt is clear to all of u.
c) in the block parameters of multiwinding transformer as soon as i enter the value of r1,r2 o l1,l2 or lm, rm the output becomes inversely reducing. whereas if the all these values are 0 i get the correct output.
please tell wat mistake i am doing.......
the design parameters are:
Po=2Kw
Vo=380V
Vi=80-100V
Fs=40Khz
turn's ratio=1.3123
Ton=13.82 usec
T=20 usec
Lp=12.20uH
Co=115.26uF
Ro=72.2Ω