...regulator circuit.pdf I realize SgtWookie's circuit is for a 5A max current, so I just need to adjust the resistor values for 1A max. As I...

...about the Dog Whisperer. I have issues with his last article entitled Troublemakers and his opinions on the certain reasons for dog behavior. Max.

The max power dissipation happens when the output current hits the limit with minimum voltage drop over the regulator. That's when the output is...

...for logic & LED's using a BUCK convertor from ebay. 3.2 -- 40 V in, out 1.25-- 35 V, max out 3A. Output dropped from 6 V to 5.99 V with 300 mA...

...log page... (day:-4) MX Log Page: Day: -4 159Ah 4.4kWh 40Vpk 35.4Apk 0.830kWpk Min: 24.2V Max: 29.2V Absorb: 240min Float:...

The max current I would draw would be 3amps I would like the ripple below a 100mV, also could you let me know what size cap I wuold need at 500...

...analogue meter. I have built several Tachos using the IC, LM2917 as suggested by Max. They only use a few parts & simple to get going & work...

Sine wave. max. frequency 10 kHz Square wave. max. frequency 30 kHz Contact closure. max. frequency 20 Hz Open collector with 20 μsec minimum

...you put a camera looking down over the stage and feed the video into MAX/MSP software, you can use the "blob detection" module to locate the...

The rectified voltage is the peak of the sine wave minus a bit for the rectifiers. At 2 amps, you will lose about 7 or 8 tenths of a volt for...

Max: That was, sort of, what I did in this one system i designed that had panels in different rooms. I would only allow contact closure inputs...

...to be approximately the same as peak which threw me off. So, the rectified voltage is the peak voltage of the transformer at its max load,...

If the label says "7.5V + 7.5V AC 2A", doesn't that mean 15Vrms at a load of 2A? If not, please help me out.

...of a 15 VAC sine wave is still 21.2 volts. With a load at the transformers max of 2A, the transformer delivers what it's label says it will...

...the 19VDC is peak, with no load. With a load at the transformer's max of 2A, the voltage drops back down to 15A. So, what happens to the...

...handle the power dissipation and won't go into thermal shutdown under max conditions since the circuit is built around them. I'm planning on...

I don't see why? Historically they have never been known as timid predators? And like most predators, are opportunists. Max.

...pin of my regulator? And If this is true and my Voltage reg. is rated for 1A max then I would surely be w/in the limits of this Volt. Reg. Lisa

...= 5.8 v leftover. 5.8v/0.02 amps = 290 ohms. Because 20 ma is the max for your standard LEDs, you raise the resistance to the next higher...

...chain of LED-s - e.g - 10x LED-s 173V×370µA÷73%→2V×43mA to sawthooth = max. or peak 86mA ← from dt·I.avg=(dt·I.pk)÷2 -- just about you don't...