The new Beta version of CircuitMaker seems to be available, not tried it yet though.
...which essentially reverses the winding usage between main and phase shift winding.
In this case both windings should show identical...
Also BCD to ASCII add 30 to each digit.
Transformer an two rectifiers rating depending on you motor current.
The diagram shows the secondary top to bottom, 12v-0-12v.
...work, the PWM controller is a little over kill at 60a! But should work.
The timer needs to be delay on operate, the one you show is Interval...
First of all i need to say thank you everybody for supporting me with this, i have posted the same topic on other forums but didnt get any help....
...reverse the motor, you just need to reverse one pair WRT the other pair.
Both pair are connected across the AC supply, (one with a series cap)....
The 10A protector was installed by the refurbisher. I'm going to try 14g and see how it performs . . . thanks-so-much for the reply, Dan
. . ....
...12g is 20amps and 10g is 30 amps, you most likely do not need any more than 12g.
What is the nature of the 10amp protector?
14g carries 15amps....
...of my motor is not 24V but 5.95V with a resistance of 8.5Ω and a max current Imax of 0.7 A. The fact that I have to use 24V means that I am...
...will handle the current for both.
The 0v will be common for both 12v outputs with a rectifier on each.
Do you intend controlling rpm?
...head is gear motor, 12v DC. The motor is stamped 1/4 hp and the max. amps (23). There is an in-line protector (10 amp). My remote control box...
...use LF solder and stay within 400F?
Finally, I did find they list a max lead temp (10s) at 300C (572F). Perhaps your thermal gradient idea...
Updated the PDF.
I believe that will do it
okej, yes it would be nice if you can do that. :)
I noticed one change needed, the cycle will automatically repeat, so I can make a mod for man start every time.
I use the MOC8106, also go direct from PIC to opto to Ir2110.
...are trying to ask about.
Your OP said that you want to measure the maximum junction temperature your devices can sustain. That indicates that...
You may have difficulty with the SMD inductor, one common application is in switch mode power supplies, so they're generally designed to minimise...
Separate names with a comma.