if not, Galco has it for $1.35 (plus about $15 shipping I'm sure)...
...should be OK, the battery is just to back up the BIOS ram, when re-powering you will get the default settings and a message saying reset BIOS.
...believe the 125 is the 120vac version.
The resistor can be obtained from a Baldor motor rep if you have one in your area, many large cities do.
..."troubleshooter" goes into a cabinet with a screwdriver. Accel,min,max, and CL are safe to fiddle with, but LEAVE IR COMP ALONE unless you know what...
...the total picture but you need real 5 volt logic that runs from DC to max clock speed with ultra low leakage that can take real-world EMI/ESD with...
Did you just steal that right out from under me while I was typing? I think you did, you one-upper. tisk tisk. ;)
The KB drives are plentiful on ebay e.g. 331507261203
...one end and the DC the other.
The AC end is fed to the stator coils. If the rotor on the AC side has slip rings it would be for rpm control.
That is for less than 120w motors, yours is way above that.
...I would use one of the DC rated power relays by P&B/Tyco PRD series that have magnetic blow out for arc suppression when using DC.
...which is superior, but more $$$.
It depend on your end objective, how much you spend.'
That is a nice motor, BTW, one of the better TM motors.
BTW do not run it in as a spindle motor without removing the flywheel first.
You need to determine whether LH or RH thread.
...decel etc as well as inhibit terminals for reversing and resetting the drive when you do so, as you should not reverse these motors under power.
...1680 rpm motor.
I am planning on using the belt system to keep the max rpm under 1700.
It is mandatory that I be able to reverse the motor.
...this also depends on how the leads are brought out on the motor.
This also is for a motor where the start/run and main windings are identical.
I don't see any reason for any significant difference, the amount of copper over each side of the lamination's is usually roughly equal.
...are P.M. motors.
A VFD takes the AC supply, rectifies it and produces a variable frequency, variable amplitude 3 ph signal to power the motor.
Each layer will have a maximum of 64 LEDs on at one time, so the cathode will take the full current of all the LEDs.
I think it might be silly...
...on how many LEDs you'll have on simultaneously and the operating current.
You need to follow max current and power dissipation specs for the drivers.
Although they are Much easier to modify by winding on a small overwind for 5v ~ 24v for e.g.;)
Separate names with a comma.