...time could be argued as one these two:
1. You join when your mother country is under attack from a vicious "other," you defend your country, your...
Does it mean that if you detect noise for only say, 54 seconds, your count will reset to zero and no LED will be turned ON?
ok, then. i was afraid i have to count the turns on this boy.. i'll do the research . ;) thank's anyway.
...clock. Digital clocks are usually set up to start at 12:00, and they count 12:01, 12:02, 12:03, and eventually the clock gets to 12:58, 12:59, 1:00,...
What is the different between AC and DC Tachometers( permanent magnet and inductive ) ?
...pickup or hall effect sensor can detect the presence or absence of a magnet and count revolutions. It is not much more complicated than that.
...I used a divide routine from piclist and divided the system frequency by the ccp count. i'll post the code i some time (i need to comment it)
...the zero power consumption), are you sure it isn't a Hall switch?
You probably are, but if not, the pin count will reveal it (reed 2, Hall 3 or 4).
...clock I'm building. It will need to be fed from a /2 (4013) and will count seconds to drive a clock dial that needs an impulse every 30 seconds....
...it and make your own schematic. Why did you need to change it to count to 15? It's a binary counter.
EDIT: Googled and found that it's still...
...listed at the moment but a short while ago I got two of these Unilab Counter Modules off eBay. They must be classroom demo stuff that's now been...
Thank you very much for taking your time to do this Soeren, you are awesome! :)
I am surprised how many resistors there are! But it looks very neat....
...to the original circuit and just improve it, keeping the component count as low as possible.
Here's the resulting circuit:
And to compare how...
How to make counter count down from 10 to 0 then from 5 to 0 then from 10 to 0 and so on.
Thanks for the reply... but my question was made using hypothetical data... I normally run my LEDs at only 6mA, since I use them as indicators inside...
Don't forget to count the current only 80% of the rating current as 20mA * 80% = 16mA, that is for the using life and light fading, it just like if...
...prime factors (remember, 1 is already not prime and so it doesn't count). So now you define that 1 is neither prime nor composite and you modify your...
unsigned int temp;
void delay(unsigned int count)
...the low byte
Variable c contains the word ( 16 bits value)
0.49 is the convertion coefficient from ADC Count to some real value.
Separate names with a comma.