...plugging may achieve what you are looking for, all depends on the motor and application.
At the moment there is no power supply on the PCB I'm testing; I'm supplying the +5V and -5V by hooking a bench power supply, which is regulated for...
...to isolate the voltage regulator on the negative side with a resistor of 10 - 100 Ohms, between the switcher and pin 20 ( V- ) of the MAX.
...motor to load inertia ratio, this is where rate of acceleration/deceleration is required in order to calculate required capacity of supply etc.
I have a ground plane covering the whole PCB and including under the MAX. For the filtering caps I have 1uF electrolytic and 1nF ceramic in parallel...
Two way switch from Home depot!! :rolleyes:
Any more information?:confused:
I wouldn't think accelerometers would be helpful at all. I'm with Max, the important measurement would be at each pivot point. By measuring these...
...usually bad form to use an output in two particular places, although it will often compile, most PLC's throw up an alarm or at least a warning.
In my programs you might find RST commands with no accompanying SET, when a bit is set by the HMI or when a WORD has been written and I only want to...
...cause but after replacing them they also died within a matter of hours.
Here you are anyway
Model No. JT-650
230-240V ~ 50Hz
24V~650mA Max: 15.6VA
...is invaluable for trouble shooting and cuts the time down immensely, especially if you have a PLC at your home/shop to save debugging on site.
This is how the terminator started out. :p
You think I'm kidding:cool:
I'll be back lol
Edit: Sorry; I couldn't resist. I had a Pumpkin Stout...
...a SET inst. This may not work with a regular OUT inst? A normal output is set off by its own rung usually, at least in the PLC's I have used.
Do you have a link for the programming instruction set for the PLC, I did not see it on the Automation Direct site?
single phase, 18Hz and allowed ripple is 7%
3 phase? 360hz <30% ripple?
...machine it would be interpolated motion, which involves servo's and feedback etc.
Normally the operator is the feedback and control loop. ;)
...be able to see this oscillation if you look at pins 17 and 20 of the MAX038 with your scope.
If this is the case, try adding 0.1 uF ceramic...
You can buy it off ebay direct from H.K. , for $4.50 P.P. , it states at 10amp it goes into O.L. and current protection.
Separate names with a comma.