BasicStampClockInput

Hello all,
I've looked extensively hard into figuring out how to make a BS2 sense a clock signal (1 to 0 or 0 to 1)on one of its I/O pins rather than the pin's individual logic state. I can't figure it out, so could anyone help?
Thanks a lot,
mpuvdd

Is this the same question as the one asked here.

If so please refrain from posting multiple threads asking the same question for reasons of manageability. If need be, give your existing thread a bump.

If this is a repeat question please let me know and I can lock one of them (tell me which one to lock).

Thanks.

Dave

They are actually different.

mpuvdd said:

They are actually different.

Click to expand...

No problem I will leave them both active.

Dave

Is there some reason you can't designate the particular pin as an input?

Well, I know how to monitor a I/O pin's state (IN# or by using VAR), I just don't know what kind of code to write in order to make the stamp add 1 to a VAR (Value) when the I/O pins changes states.

In Basic, you can usually INC a register.

(I've never used Basic Stamp so I'm kind of guessing here.)

It sounds like you're trying to detect rising and falling edge on a pin. On some microcontrollers, you can set up an interrupt that automatically calls your function when the level on the pin changes - I have no idea whether this is possible on the Basic Stamp.

To detect if a pin has changed using a simple polling-loop, you can keep a record of its level, and each time round, compare its current level with what it was last time.

psuedocode:
EDIT: Just thinking that might be a problem if the input changes at the wrong moment.

However you're doing it, even with interrupts, note that if two changes occur too close together you're going to miss something.