All About Circuits

Mitutoyo SPC connector

Search Forums New Posts
J

Thread Starter

jpanhalt

Joined Jan 18, 2008
11,087
I have a Mitutoyo 543-252B digimatic indicator. The cable seems to be Mitutoyo part #905xxx

It looks like:




They are quite expensive. Does anyone know of a plug that might be substituted.

Edit: Approximate dimensions for socket are: 10.5X4.9 mm; contacts are about 1.7 mm on center.
Thanks. John
 
Last edited:
J

Thread Starter

jpanhalt

Joined Jan 18, 2008
11,087
Ken, Thanks.

If I can't find one cheap, I may just solder some Be-Cu strips to a PCB and keep pressure with a piece of sponge -- or even solder directly to the contacts in the indicator. They are just like a card edge connector etched on a PCB.

I can't justify spending $40 for a simple plug when the whole indicator, new in-box, was not much more on ebay. John
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A Should I design a 'Connector Test Board'? General Electronics Chat 14
K I want to charge and send data sing an usb c connector. Digital Design 7
Pushti Ujeniya USB2.0 type C connector routing Analog & Mixed-Signal Design 1
john4953453 Broken U.FL / IPEX antenna cable connector on Meta Quest 2 controller – repair options? Technical Repair 0
E Pinout of Ethernet connector RJ45 PCB Layout , EDA & Simulations 14
Similar threads
Should I design a 'Connector Test Board'?
I want to charge and send data sing an usb c connector.
USB2.0 type C connector routing
Broken U.FL / IPEX antenna cable connector on Meta Quest 2 controller – repair options?
Pinout of Ethernet connector RJ45

You May Also Like

Top